Detects residual Protein in water for use in educational programs.
- Desiccant vial with flip-top lid
- Water-resistant color chart
- Customizable label
- 50 test strips
Showing 257–272 of 378 results
Test paper measures glucose levels in osmosis/diffusion experiments, urine analysis (educational only), and food science studies.
The Glucose test paper detects 0.1 – 2.0% glucose. Our Glucose Test Strips can also be used for similar purposes, however, they are plastic strips rather than paper and measure from 0-3000 mg/dL rather than percentages. The strip can be used to measure glucose levels in osmosis/diffusion experiments, urine analysis (educational only), and food science studies.
Instructions:
1. Remove one test paper from the bag using tweezers. Do not touch the test paper with your bare hand. The strip is 4 inches in length, and may be cut into smaller lengths if needed.
2. Dip the test strip into the solution being tested for 1-2 seconds.
3. Remove the strip from the solution.
4. After 60 seconds, compare the test strip to the color chart.
Note: In solutions containing oxidizers, a false positive may be observed.
Disclaimer: Precision Laboratories products are not approved for use as medical devices. Products and product information is for informational purposes only and not intended for use to diagnose, treat, cure or prevent any medical condition. Consult a medical doctor when needed.
AD3000 is a microprocessor-based conductivity, TDS and temperature meter. The autoranging feature of the EC and TDS ranges automatically sets the instrument to the scale with the highest resolution.
Measurements are compensated for temperature effect automatically (ATC) or manually (MTC) with the conductivity probe with built-in temperature sensor. It is also possible to disable the temperature compensation and measure the actual conductivity.
AD8000 is a microprocessor-based pH, ORP, conductivity, TDS and temperature bench meter. Relative mV feature is also provided. The autoranging feature of the Conductivity and TDS ranges automatically sets the instrument to the scale with the highest resolution.
pH measurements are compensated for temperature effect automatically (ATC) using AD7662 temperature probe, while the EC readings can be compensated automatically (ATC) using the conductivity probe with built-in temperature sensor or manually (MTC). It is also possible to disable the temperature compensation and measure the actual conductivity.
AD1020 is a professional bench meter for pH, ORP (Oxidation Reduction Potential), ISE and temperature measurements. Relative mV readings are also provided.
AD1000 is a professional bench meter for pH, ORP (Oxidation Reduction Potential) and temperature measurements. Relative mV readings are also provided.
Detects residual Protein in water for use in educational programs.
Taste test paper test for the genetically controlled ability to taste PTC.
ITEM CODE
EM_1161 IV Derm Sterile Dressing 6x8cm
Pocket-sized, lightweight vial
Color chart protected in vial
Semi-customizable label
Bulk quantities available
100 test strips
Detect the strength of quaternary ammonium compounds in sanitizers.
Available in
106-12V-100 12 Vials (#1020), 100 Strips/Vial
106-144V-100 144 Vials (#1020), 100 Strips/Vial
106-500V-100 500 Vials (#1020), 100 Strips/Vial
Oil test paper allows the rapid and reliable detection of oil contamination’s of water and soil. The sensitivity largely depends on the nature of the respective hydrocarbon.
Platform | Qualitative test paper |
Analyze | Oil |
Point of Charge | Oil – 250 mg/L petroleum ether, 10 mg/L gasoline (high octane), 5mg/L fuel oil, 1 mg/L lubricating oil |
Color Change | Oil – pale blue → dark blue |
Length | 70 mm |
Width | 20 mm |
Shelf life | 3 Years |
Storage temperature | 4−30 °C |
Scope of delivery | 100 test strips in a plastic box |
Hazardous material | No |
Quick response detection of quaternary ammonium compounds used in disinfection.
Portable incubation of up to 45 dipslides.
pH paper used to determine if a solution is alkaline.
AD11P: Replaceable ec/tds/temp electrode for ad31 & ad32.
AD32P: Replaceable ec/tds/temp electrode for ad31 & ad32.
AD33P: Replaceable ec/tds/temp electrode for ad33 & ad35.
Detect low-range levels of chlorine dioxide when used for disinfection.